Sign in to our website and become an InMoov member. It will allow you to post message, pictures, and share with others InMoov builders. It's just one click away!
Username or Email Address
Isabel posted an update 11 months, 3 weeks ago
Just starting my InMoov journey! Almost finished printing the forearm and will start the assembly.
This is my first time printing this extensively with ABS, does anyone have any tips for getting rid of the waviness in the walls and the infill not fully attaching to the wall? I’m using an Ultimaker 2 🙂
congratulations on your progress!
for the ripples is wobble, you find on thingiverse anti-wobble pads, you can also separate the top of the threaded rods of the frame, the set gives a good result.
2nd solution: it is possible to replace with trapezoidal rods without skates but you have to change the firmware.
for filling I do not know too much, maybe a little lack of material?
the more you can adjust your printer and the less you have to sand.
good continuation !
thanks for the tips, ill give them a try!