A few months ago I was asked by an American set designer, if I would let them use InMoov hand for to make the front cover of The Atlantic magazine.
Attribution is to be expected inside the magazine. Behing abroad, I have not the chance to buy it for to check it out.
Looking at the result, they did a good job on the finishing touch. If I remember correctly, it was printed in PLA with a 0.3mm thickness. They did a finishing coating with paint, but I would guess they had to use a primer with a good sanding job.
Here is the article of CNN, which came out a few weeks ago.
 |
| Photo Bart Cook |
 |
| Photo Bart Cook |