Sign in to our website and become an InMoov member. It will allow you to post message, pictures, and share with others InMoov builders. It's just one click away!
Username or Email Address
Password
Remember Me
FrankChalabi posted an update 3 years ago
Statut quo!
FrankChalabi posted an update 3 years, 6 months ago
I need help please Gael ! I want to move the eyes , the jaw von Inmoov, i need to speak with my inmoov. Thank you everyone.
did you check here? http://inmoov.fr/neck-and-jaw/
and for the eyes is here. http://inmoov.fr/eye-mechanism/
Thank you Nomadin. The problem is with the calibration, MyRobotlab and the coding.
ah okay then.
FrankChalabi posted an update 3 years, 9 months ago
Bonjour Allo Makers I have a problem with to connect and programming my robot !
FrankChalabi posted an update 3 years, 11 months ago
Hello
I bought the full nervo cards for $ 76 and today I got to soldering these cards unfortunately only got half of them. Either the part for a single arduino mega board. in short, I only received part of the body.
I think you need 2 sets for the whole Robot
FrankChalabi's profile was updated 4 years ago
FrankChalabi posted an update 4 years, 3 months ago
yes, I’m finished with the printer. I have difficuklt to output the potentiometer and to input it in the element. Can you explain to me the role of the potentiometer for all the part of Inmoov. Alos, how to output it and when i put it out the servomoptor will run without it ? Because i have put out one and i have sold all the part but the…[Read more]
FrankChalabi posted an update 4 years, 4 months ago
Will a RASPBERRY camera (Seeed Studio Raspberry Pi 4 Model B 2 Go Camera Module V2) do the trick for our Inmoov. If yes, how do you connect it to the ARDUINO or other? thank you so much
No idea yet about the RPI camera but I plan on trying it. So far I have MRL manticore and Nixie running on a RPI 4 8GB connected via USB to an Arduino Mega running MRLComm. I’ve tested servo control for head rotation and jaw so far. I have the eyes printed but still need to put them together. I ‘ve been looking for a stand for the head that sup…[Read more]
FrankChalabi posted an update 4 years, 6 months ago
Today I’m going to start printing the shoulder with PLA and ABS whatever you think of these 2 materials. I prefer PLA because I don’t need to apply glue and I just had a 2nd printer, an ultimate monoprice which uses only 1.75mm wire
FrankChalabi posted an update 4 years, 8 months ago
Bonjour TLM Je suis entrain de réaliser la partie pensante du robot, soit la tête complète avec les yexu et le mécanisme. Ce qui m’intrigue et ne me laisse pas poursuivre mon chemin avec mon imprimante 3D , ce sont les modifications ou les remplacement des pièces par d’autres. Ma question: Est-ce que les modifications approuvées par M. Lange…[Read more]