I have to file all the dovetail pieces quite a bit to get them to fit. I guess it’s probably a printer calibration issue but mine is close enough that I would rather file some pieces than risk making it worse by fiddling with the settings.

Thanks. I have to chave them down a good amount to even get them to even fell, then I use vise grips or hammer with board to fit them.

I would figure if your printing the same parts with the same printer, all parts would be same x,y sizing even if the calibration is off. I could see an issue if decided to print using another printer though (which I’m not).

i thought that too. I saw some elephant foot on the base of my torso pieces. After removing them all around, I still have to shave the dove tails to get it to fit. I’m not complaining, I like the snug fit. I was just curious if its normal.