-
Troy posted an update 7 months ago
Hey,
Just a noob question of the day.
I have only just built my inmoov to the point where I am testing all the servos.
I guess I’ll probably have to rewire it but for testing I simplified it by having all the servos connect in to one microcontroller.
This works to an extent. Except for the fact there are no pins free to add more servos.
So I plan on following the wiring diagram and adding two Arduino megas.My question is do you need the nervo board set up? Because I was under the thought that I didn’t need it at all but I am normally wrong lol
In any case if I do is there a soldered set of these boards available?
Thanks
Troy
@troy1980
Active 3 months ago
i am having trouble with the ultrasonic sensor i cant seem to get it working at the moment. when i try the test is comes up with attribution error not found. and also can i change the pins i wan to use? it says 63 and 64 but i have know idea where they are on the arduino mega haha. i was going to change them but didnt know if i could as it […] View