prasket – InMoov

prasket posted a new activity comment 5 years, 10 months ago

Unfortunately I have not seen any indication that this is the case.

Gael Langevin replied 5 years, 10 months ago

Some models are trying to walk…
But it’s a matter of time.
http://myrobotlab.org/content/version-2-legs

prasket posted an update 5 years, 10 months ago

Hello All! What is everyone (especially in US) using for power supply’s for their inMoov? All the info I can find so far is outdated links mostly from 2016.

I have my finger kit going but not enough juice for the HK15298’s I picked up. Figured I might as well figure out my power needs now. Especially since I just finished printing the…[Read more]

prasket posted a new activity comment 5 years, 10 months ago

Hi Mark – The prusa bed is 250x210x210 but that might be large enough. I thought some of the chest pieces might have needed a larger bed.

View Conversation

Mark Seaton replied 5 years, 10 months ago

The original design was for everything to be able to be printed on a 120mm x 120mm bed. so you will be fine. Like I said, the legs are the biggest and I still had a little room on my 250mm bed when I did the thighs.

prasket posted an update 5 years, 11 months ago

Hello All! Justin getting started on InMoov project!

Already ran into power issue though with the finger-starter kit. I even tried to power with the power adapter that came with my Arduino Uno kit. I might just go ahead and look into getting the 6V 60Amps Switching Power Supply mentioned by Gael in the latest BOM update.

While I work on…[Read more]

Mark Seaton replied 5 years, 10 months ago

Isn’t the Prusa 250mm bed?
The only parts that need a 250mm bed so far anyway are the legs. So you have a while to go.
And I have printed in PLA all the way, as long as you have your settings right that should be strong enough anyway.
- prasket replied 5 years, 10 months ago
  
  Hi Mark – The prusa bed is 250x210x210 but that might be large enough. I thought some of the chest pieces might have needed a larger bed.
  - Mark Seaton replied 5 years, 10 months ago
    
    The original design was for everything to be able to be printed on a 120mm x 120mm bed. so you will be fine. Like I said, the legs are the biggest and I still had a little room on my 250mm bed when I did the thighs.

prasket posted a new activity comment 5 years, 11 months ago

Gael uses ABS but states PLA is OK. I personally started with ABS but moved over to PLA as I could not keep the temps steady without an enclosure for ABS. I have seen lots of others with PLA as well.

View Conversation