Sign in to our website and become an InMoov member. It will allow you to post message, pictures, and share with others InMoov builders. It's just one click away!
Username or Email Address
Password
Remember Me
Richard Tracy, II posted an update 7 years ago
I finished the head and now working on the torso. I tried to fit the pieces but they won’t connect together, do I have to shave the dove tails down; it seems like a lot of shaving?
I have to file all the dovetail pieces quite a bit to get them to fit. I guess it’s probably a printer calibration issue but mine is close enough that I would rather file some pieces than risk making it worse by fiddling with the settings.
Thanks. I have to chave them down a good amount to even get them to even fell, then I use vise grips or hammer with board to fit them.
I would figure if your printing the same parts with the same printer, all parts would be same x,y sizing even if the calibration is off. I could see an issue if decided to print using another printer though (which I’m not).
Could it be that your printer is over extruding so there is a little more material around all the edges?
I had similar issue with my original printer. Have you tried gently heating the parts before pushing them together?
i thought that too. I saw some elephant foot on the base of my torso pieces. After removing them all around, I still have to shave the dove tails to get it to fit. I’m not complaining, I like the snug fit. I was just curious if its normal.