• theDVSguy posted an update 5 years, 3 months ago

    @admin hello, Need to clarify my board builds. Pictures on the website seem dated. Can someone help in regards to my markups on these pics.
    My plan is to run the same voltage across the board and also to use 5v for fingers sensors etc. I think I figured out all the jumpers etc
    but I would like some feedback. Also not sure if I need to do…[Read more]

    • Hello,
      Here is how to solder if you want the same voltage on all servo.
      This below setup will give a 5V for PIR sensor and finger sensors.
      InMoov front soldering
      InMoov back soldering

  • theDVSguy posted an update 5 years, 3 months ago

    Does anyone know if the Shop is open for buisness and shipping items ?

  • theDVSguy's profile was updated 5 years, 4 months ago