Sign in to our website and become an InMoov member. It will allow you to post message, pictures, and share with others InMoov builders. It's just one click away!
Username or Email Address
Password
Remember Me
theDVSguy posted an update 5 years, 1 month ago
@admin hello, Need to clarify my board builds. Pictures on the website seem dated. Can someone help in regards to my markups on these pics. My plan is to run the same voltage across the board and also to use 5v for fingers sensors etc. I think I figured out all the jumpers etc but I would like some feedback. Also not sure if I need to do anything on the backside. Also if anybody has any recommendations that I should worry about for future consideration please let me know.
Hello, Here is how to solder if you want the same voltage on all servo. This below setup will give a 5V for PIR sensor and finger sensors.