Assembly Sketchs

Comments 6

1. Pingback: Introduction to Flex Sensor with Arduino | xuemin's blog
2. 

   oldfarmhand September 14, 2015 at 1:59 pm

   Thank you for all of the color Assembly Sketches It makes Inmoov so much easier to assemble when you know where the parts go, without them its like a doing a jigsaw puzzle without a picture to go by. It can be done but boy it takes a whole lot longer.

   Log in to Reply
3. Pingback: MIDTERM PROJECT REMOTE CONTROL ROBOTIC HAND | Art B2011 Medium Workshop Physical Computing
4. Pingback: Kablosuz Eldiven ile Kontrol Edilen Arduino Robotik El – Üreten Atölye | Arduino, Raspberry Pi, esp8266, Projeler
5. 

   Rogerio Luis de Lima December 12, 2018 at 9:25 pm

   Hi
   Regarding the screws in the finger sections I didnt found it in the parts package to print, are you using metal screw or printed screw? In case of printed could you please share the respective stl file with me please (rogerlima2108@gmail.com).

   Log in to Reply
   • 

     Gael Langevin December 12, 2018 at 9:32 pm

     Hello,
     For the fingers, I use filaments 3mm, you can look at the “FingerStarter” tutorial.
     For other bolts and screws, look in the “Hardware and BOM” page.

     Log in to Reply