Sign in to our website and become an InMoov member. It will allow you to post message, pictures, and share with others InMoov builders. It's just one click away!
Username or Email Address
Password
Remember Me
Steve Rayner posted an update 4 years, 6 months ago
Do we need support when printing BackDoorLeft and BackDoorRight? The build yours guide indicates we do not need support. Cura won’t seem to slice them if I turn support off which is a bit odd. But with support Cura estimates 10hours and 48minutes. Since I updated Cura the printing times have increased a lot.
Maria’s back door right and left were printed without support. Each one printed in 7.5 hours with 0.15 mm layer height. They look good in white; now I wonder if they should be black?
I went with some custom support in the end. It took just over 8 hours for each half. I’m printing everything in white. But yes I think it might look better if some of the parts were black, just to break things up a bit. Nice thing about this project is you can always just redo and change things.