• Isabel posted an update 6 years, 2 months ago

    Currently finalising the hardware for my robot Jinn!

    Has anyone been able to use an Arduino Pro Micro fro the neopixel ring? It works perfectly when run through Arduino but I’m unable to connect through MRL. Anyone have any tips? I want to avoid buying a nano since i have 5 extra Pro Micros laying around.

  • Isabel posted an update 6 years, 4 months ago

    Making progress! Almost done with both arms as well and will attach once mid stomach is complete.

    I am having a problem with the two parts under the Kinect simply not fitting. Does anyone have any suggestions for making it fit or have an edited .stl that works better?

  • Isabel posted a new activity comment 6 years, 8 months ago

    thanks for the tips, ill give them a try!

  • Isabel's profile was updated 6 years, 8 months ago

  • Isabel posted an update 6 years, 8 months ago

    Just starting my InMoov journey! Almost finished printing the forearm and will start the assembly.

    This is my first time printing this extensively with ABS, does anyone have any tips for getting rid of the waviness in the walls and the infill not fully attaching to the wall? I’m using an Ultimaker 2…[Read more]

    • Hello !
      congratulations on your progress!
      for the ripples is wobble, you find on thingiverse anti-wobble pads, you can also separate the top of the threaded rods of the frame, the set gives a good result.
      2nd solution: it is possible to replace with trapezoidal rods without skates but you have to change the firmware.
      for filling I do not know too…[Read more]