Sign in to our website and become an InMoov member. It will allow you to post message, pictures, and share with others InMoov builders. It's just one click away!
Username or Email Address
Password
Remember Me
Adithya NS posted a new activity comment 7 years, 1 month ago
Thank you very much for the settings Sir. I will try them today and will get back to you if I run into some problem.
Regards, Adithya
Sir I’m using Anet A8 printer with Cura software. As you told Sir, the corners are not sharp and nozzle temperature was bit high. Sir which slicing software you recommend me to use and also can you give me your slicer settings so that I will try them to get better understanding of 3d printer.
Adithya NS posted an update 7 years, 1 month ago
Hello Sir, Thank you very much for Sharing your project so that students like me can learn Robotics. I have printed some parts already. Sir can you share printing guide for all the parts. I would be of great help if you could do it. I’m using ABS. Thank you very much Sir.
Printer setting for Basic Parts (ED3v6 with 0.4mm Nozzle) ———————————– 3 perimeters 3 solid layers 30% infill 30mm/sec perimeters speed 30mm/sec Solid Layer speed 80mm/sec Infill speed 0.3mm layer height 0.3mm Z -Hop -Lift the nozzle between moves to prevent scarring on surface finish Top/ Finish Layers =…[Read more]
Watch your acceleration speeds, looks like they are too fast. If in doubt, slow down on speeds. And if your printer isnt properly calibrated the corners will be not sharp as yours arent. That can be tweaked with accel speeds and jerk in the eeprom settings. Also it depends onwhat printer you have. But 80mm/s infill is pretty fast. Start with slow…[Read more]