• allen toups posted an update 4 years, 2 months ago

    good day, I’m Allen and new to inmoov can’t wait to get started. I’ve been reviewing everything, and learning as i go. I have a question about wiring, what size, anything special Ii need to know? one more thing, the parts that I print what % of infill should i use? things for any help

    • Infill %- varies from part to part- most people use the standard- 30% with 3 Perimeters and 3 solid layers, which is good allrounder, personally I use a different setting for every different part, it just depends on what the part is for- the best wire to use is the type that doesn’t catch on fire….lol

    • Remember a very important thing many people tend to forget when slicing the parts.
      When lowering down the resolution and keeping a 3 shell perimeter you also loose strength.
      Say if you print at resolution 0,5mm with a 3mm perimeter with an infill of 30%, it is much stronger than if you print at resolution 0,2mm with a 3mm and an infill of 30%.
      The result of lowering down the resolution also lowers down the width of the perimeter.
      So if you print at 0,2mm resolution you need to increase your perimeter shell to 7, and keep an infill of 30%.