Sign in to our website and become an InMoov member. It will allow you to post message, pictures, and share with others InMoov builders. It's just one click away!
Username or Email Address
Simon posted an update 8 years, 11 months ago
Finger Tip Sensors. Hi Gael, do you have any information on how to connect the sensors and or wiring besides the Assembly hand guild? I am not sure on what control board to uses.
The sensors are connected to the Nervo shield board. The best is to add some resistances for each sensor connection.
// Flexiforce quick start example
// Reads A0 every 100ms and sends voltage value over serial
// Start serial at 9600 baud
// Read the input on analog pin 0:
int sensorValue = analogRead(A0);
// Convert the analog reading (which goes from 0 – 1023) to a voltage (0 – 5V):
float voltage = sensorValue * (5.0 / 1023.0);
// Print out the value you read:
// Wait 100 milliseconds