It hasn’t been working for ages.

Gael has a new video on the main page is a link or his youtube channel. it is about the elbow, but has info on exactly how to set the servo’s

My first parts were printed at .24 and didn’t fit so well. I then printed at .15 and they all fit together nicely. Also looked a lot better as finished product.

That is going to be one colourful robot 🙂

I have an anet a6 and found that I got best results using slic3r pe and using .16 layer. I also used 30% infill. First piston I did, I had .24 and it was a pain, when I went to .16 all others are smooth as.

I use .16 layer height. and have just made sure my printer is setup correctly. making sure there is no wobble or ringing etc. The first piston I did was the neck piston and it was terrible, I had to put some dry lube in and put it in a vice and turn it with pliers to get it to move, but after I got me printer sorted out, all the other pistons etc…[Read more]

No walking available yet, only legs for display as is suggested on legs page.

The original design was for everything to be able to be printed on a 120mm x 120mm bed. so you will be fine. Like I said, the legs are the biggest and I still had a little room on my 250mm bed when I did the thighs.

Isn’t the Prusa 250mm bed?
The only parts that need a 250mm bed so far anyway are the legs. So you have a while to go.
And I have printed in PLA all the way, as long as you have your settings right that should be strong enough anyway.

nice job. what are the specs on the nuc?
I have been searching for a tablet, but in Aus they are so expensive.

There are stl files available for both round and square. You need to print for which one you need, If the file is not on here then go to thingiverse and search for inmoov you will find it all.

yep. got an email just recently and was about to report it here, but you beat me to it.

Double check you have the correct version of java for your pc, also did you create mrl folder on root C: ?
when you first start mrl did it pop up with screen and show it is starting?

My first screw parts were an extremely tight fit. I put it in a vice and used a wrench to wind it in and out, eventually it got better. After that I printed everything with .15 layers and all is so much better. No problem with any of the pieces fitting since.

Is he a surgeon? Why has he got gloves on?