• Profile picture of Grant

    Grant posted an update 7 years, 9 months ago

    Hey, what filament works best for printing Inmoov. ABS or PLA?

    • Profile picture of Wayne Kennedy
      Wayne Kennedy replied 7 years, 9 months ago

      I am using PETG, and really like the strength and finish that I’m getting. Mostly I like that it prints without odour or fumes, as I find ABS quite unpleasant to have printing in the same room where I am working.

  • Profile picture of Grant

    Grant posted an update 9 years ago

    Hello everybody. I haven’t been on in a while, 8th grade got a lot harder, but I am happy to say that I am almost done printing all of the pieces to the right arm. I am just waiting for Amazon to stock back up on HK15298B servos. I will share my results as soon as I am done assembling the full arm.
    Good luck to you all,
    Grant

  • Profile picture of Grant

    Grant posted an update 9 years, 2 months ago

    Hey guys,
    I had a question about the finger sensor file. Is it only for one finger (and if so which one) or multiple and is it only used for the top of the finger or the entire thing? Thanks!

  • Profile picture of Grant

    Grant posted an update 9 years, 3 months ago

    Hey I had a question. What type of touch sensors are used in the finders? I want to add some to the hand but I can’t find any that would fit. Does anyone have any suggestions? Thanks!

    • Profile picture of Gael Langevin
      Gael Langevin replied 9 years, 3 months ago

      Hi Grant,
      Currently it is a very basic sensor made of carbone foam. It is not very accurate.
      You can find information here under or make a search for all related info on the site using the search button.

      Hand and Forarm

  • Profile picture of Grant

    Grant posted a new activity comment 9 years, 3 months ago

    Thanks Marten de Groot! I will probably start there. I have got the servos ordered.

    View Conversation
  • Profile picture of Grant

    Grant posted an update 9 years, 3 months ago

    Hi everybody I am new to the community and I hope to start my Inmoov on Friday. I was wondering if anyone had any suggestions on where to start. Thank you!

    • Profile picture of Marten de Groot
      Marten de Groot replied 9 years, 3 months ago

      Hi Grant,

      Welcome to the InMoovers 🙂

      I think it’s good to start with the Finger Starter kit so you can start playing around with MyRobotLab during all other printer actions.

      Have fun… 🙂