Awesome! They look fantastic.

Oh, very nice. Magnifique!

I’m asking the same question where is for download?

Hay Richard,,,
You can build the chest plates Front and Back and the 2x vertical Centre beams – but “don’t permeant join those 4 section together—
Normally a permeant Join of anything without having the Electronics/Servos/Wires Mapped Out or a Escape Plan ,,,, is a No,,, No,,,
You can do a « Dry Run » at putting Section together – Small bits of t…En afficher davantage

I have to file all the dovetail pieces quite a bit to get them to fit. I guess it’s probably a printer calibration issue but mine is close enough that I would rather file some pieces than risk making it worse by fiddling with the settings.

Thanks. I have to chave them down a good amount to even get them to even fell, then I use vise grips or hammer with board to fit them.

I would figure if your printing the same parts with the same printer, all parts would be same x,y sizing even if the calibration is off. I could see an issue if decided to print using another printer though…En afficher davantage

i thought that too. I saw some elephant foot on the base of my torso pieces. After removing them all around, I still have to shave the dove tails to get it to fit. I’m not complaining, I like the snug fit. I was just curious if its normal.

Eh oui, le problème n’est pas encore complètement résolu. Sébastien bosse dessus mais il ne trouve pas la solution pour l’instant…
Merci pour l’info.

Bonjour
Nickel tous les contenus fonctionne normalement.
Merci

Gearbox’s have been test Printed a few times to work out any bugs … still a couple of Minor bugs to fix—I wanted them to be Print&Play ,,,, No to very little clean-up work needs to be done just screw and bolt them together so fine tuning is everything– I’ve got some time off so want to get this section finished ,,,,as you can see the design lo…En afficher davantage

Hello,
Did you flash the Arduino with the MRLComm.ino which is located in the:
C:\Myrobotlab\myrobotlab.1.0.2340\resource\Arduino\MrlComm/MRLComm.ino

Awesome pictures! Hopefully someday maker fair will be in my neck of the woods and I’ll be able to go. I like the bottom half of your base I can’t really tell but does it go up and down and do you have any diagrams to share . I’ve been thinking similar like yours but a little different and yours might save a couple of linear actuators .…En afficher davantage

Hello Mindless,
I’ve had similar problems, and more recently I was unable to upload the latest photos of Fred’s foot I just printed, however I had an internal server error when going to the album to upload.

There is a function within MyRobotLab (MRL) to send email
http://myrobotlab.org/service/Mail
There is no reason why you can’t add this functionality to your robot, once you have done that, Please let everyone know how you went about it!

good job thomas
Can you put on thingiverse the top of the thigh to fix the leg on inmoov. thanks thomas

Hi what do you mean ? Could you explain please. The new parts are on thingiverse:
https://www.thingiverse.com/thing:2557484
or are you missing parts ?

Nice work—Thanks for posting your STL Files too,,,

Bonjour, Oui 1.75mm ou 3mm Filament est bon