Depends on if your happy with fingers that can move buts that all they can do,,, the sensors allow the fingers to realise when the have touch an object and stop the servos from moving any further,, this allows Inmoov to pick up objects that have different sizes/shapes,,- now this all done with the software,,, so this is where the guys over at…En afficher davantage

You have to look harder… http://inmoov.fr/inmoov-stl-parts-viewer/?bodyparts=Forearm-and-Servo-Bed

Just cant get over how good those eyes look.

Very nice work Marco- I actually printed out some pupils today with the blue you used and a shade down,,, trying to work out which one looks better so thanks for posting the picture ,, if you ever want to get rid of the gaps between the Gear Teeth when print small gears such as the Potentiometer gear or Pin Gears- use  » 2 perimeters » with 50% to…En afficher davantage

Very nice system,,,,, the design reminds me of that Japanese robot they finally got walking around,,,, Mr Gael has the legs designed but not released and he’s kept that organic look to them which very hard to copy- but getting the walking operation with the toque vs speed to work without him falling over is going to be a hell of a c…En afficher davantage

At the moment you still get what you pay for–,, have I good at the “Hardware Map & B.O.M” under the “Build Yours” tab- it will point you in the right direction on what servo will “burn-out” or are- “Noisy”—,,, -I’ve got heap of deferent servos left over from my R/C days mainly futaba ,, they have been flogged to death for many many years and ar…En afficher davantage

Very nice finish- personally I would do the front and back chest plates and then start the shoulders/ biceps and forearms,,, that way you won’t have body parts laying all over the place getting mixed up,, ,—like me….lol,,

You need to order two SIP resistor_network they look like this:
http://www.thedigitalshop.net/iccpix/sip-b-10.gif
http://www.electronicshub.org/wp-content/uploads/2014/12/Network-Resistors.jpg
The NervoBoard has the option to solder one at the sensor side.
You need a 8-pin version (with seven resistors).
I only don’t now which value you need to…En afficher davantage

Hi, Marten.
I understand now where to connect the SIP resistor. I note that there are type A and type B in those resistor networks. Is the one I need the type A? (isolated). I have been asking around but haven’t yet found anyone who knows or who knows which value I need. If you find out can you reply please?

HI Marten.
I will probably re-print the finger-tips tomorrow and start again as I’m not happy with them.
I am trying to get the measurements you asked for but the numbers are changing continually – going radically up and down. I have attached the red and black to each wire in the finger and have tried with a couple of fingers where the tip…En afficher davantage