You have to look harder… http://inmoov.fr/inmoov-stl-parts-viewer/?bodyparts=Forearm-and-Servo-Bed

Just cant get over how good those eyes look.

Very nice work Marco- I actually printed out some pupils today with the blue you used and a shade down,,, trying to work out which one looks better so thanks for posting the picture ,, if you ever want to get rid of the gaps between the Gear Teeth when print small gears such as the Potentiometer gear or Pin Gears- use  » 2 perimeters » with 50% to…En afficher davantage

Very nice system,,,,, the design reminds me of that Japanese robot they finally got walking around,,,, Mr Gael has the legs designed but not released and he’s kept that organic look to them which very hard to copy- but getting the walking operation with the toque vs speed to work without him falling over is going to be a hell of a c…En afficher davantage

At the moment you still get what you pay for–,, have I good at the “Hardware Map & B.O.M” under the “Build Yours” tab- it will point you in the right direction on what servo will “burn-out” or are- “Noisy”—,,, -I’ve got heap of deferent servos left over from my R/C days mainly futaba ,, they have been flogged to death for many many years and ar…En afficher davantage

Very nice finish- personally I would do the front and back chest plates and then start the shoulders/ biceps and forearms,,, that way you won’t have body parts laying all over the place getting mixed up,, ,—like me….lol,,

You need to order two SIP resistor_network they look like this:
http://www.thedigitalshop.net/iccpix/sip-b-10.gif
http://www.electronicshub.org/wp-content/uploads/2014/12/Network-Resistors.jpg
The NervoBoard has the option to solder one at the sensor side.
You need a 8-pin version (with seven resistors).
I only don’t now which value you need to…En afficher davantage

Hi, Marten.
I understand now where to connect the SIP resistor. I note that there are type A and type B in those resistor networks. Is the one I need the type A? (isolated). I have been asking around but haven’t yet found anyone who knows or who knows which value I need. If you find out can you reply please?

HI Marten.
I will probably re-print the finger-tips tomorrow and start again as I’m not happy with them.
I am trying to get the measurements you asked for but the numbers are changing continually – going radically up and down. I have attached the red and black to each wire in the finger and have tried with a couple of fingers where the tip…En afficher davantage

tres bonne idee merci d avoir partagé

Had some trouble getting ABS to stick to the plate, so purchased Wolfbite glass bed adhesion solution, now even the larger prints are sticking with no issue. Also discovered room temperature makes a big difference. I prefer 16 degrees room temperature, but my ABS printing seems to work best above 20, so I have to sacrifice a bit.

fantastic

Hi Guy’s,

I like to remind you, it’s not aloud to use the InMoov in a commercial way !
InMoov Robot by Gaël Langevin is licensed under the:
– Creative Commons
– Attribution
– Non-Commercial license.
https://creativecommons.org/licenses/by-nc/3.0/

Thank you for your understanding.

Regards,
Marten

Cool… nice to see someone experimenting with the drive system,,,
You will have to keep us updated on the progress or even a quick tutorial once you’re finished,,,

hello ross hey nice job you do my idea but me i use drill motor
you cas see here my work

https://www.facebook.com/photo.php?fbid=10205427365825354&set=a.2973743144393.2152594.1286230239&type=3&theater