Nope,,,, HS-805BB are the cheapest out there for their size,,, prices are all over the place with servos-,, have a look at quite a few web-shops before buying- you should be paying around $35usd for them- but check out the “postage cost” before buying ,,,

Try these ones, they are the same as the HS-805’s but only $27 USD.
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXLN94&P=4#technotes

for the large servos I strongly recommend using heat-up fuses so it stops the current before burning up the servo. I anyway had expected that these servos would come with overload protection but the manufacturers seem to like them burning out …

ehhh, nice perspective. looks like a lot of work to position the many parts at the right location and orientation

at least for the head you might find alternate parts that help to reduce the gaps. you can also try to fill the gaps with filler, 3d filament pistols or use a dremel filled with short filament pieces and do something like smoldering the pieces together. be prepaired to do a lot of sanding to get a good result

When It comes to using fillers/putty’s- there’s basically 4 types- stuff you use for -plaster board- in home building /renovation work– and there’s -Model putty- and there’s also the type for auto repairs with fibreglass reinforcement and a version without fibreglass reinforcement – and there’s Plaster Of Paris and Moulding Types
The Plaster boa…En afficher davantage

Thanks Guy’s

I think I am going to attack it with a heat-gun and slowly heat up some parts and see if I can bend some parts a bit in to shape.

To be honest I don’t really like a smooth baby bottom head 😀
Getting the gaps closer together is enough for me.
I will post some pictures when it done.

These are models to buy. The spirit of this site is open source.
Will you post them as open source?

BTW, the setup will be the same like this:

– Alan Timm (@gestalt73) September 16, 2016

Click on the home page http://inmoov.fr/
Mid-way down you will see « Builders near you »

Yes, how do I place a marker on the map.

Thank you, all

Hello,, are you talking about the ¼ scale HITECH -HS-805BB- which are the big ones for his biceps/shoulders and stomach,,etc.,,, or the medium size for his Forearms..?—or both,,, there’s a million and one servos and sizes out there on the market-,,, I will do I couple of pictures with measurements of the Inmoov servo housing this week so peop…En afficher davantage

the million and one unfortunately is the truth – make sure you get the right dimensions to make them fit onto the printed parts or be prepared that you need to modify the parts before printing to match your servo’s dimensions.
you can also find some alternate parts in gaels alternate section or on thingiverse that will fit other servo dimensions.…En afficher davantage

you might have better sources for IR sensors – my own experiments and results are rather poor. Another issue might be integrating the sensors result into the control loop. I think without an optical identification of the part you want to grab you won’t be able to gain much. Another issue is the current joint angels of your finger parts. These…En afficher davantage

Great and Nice work MindLess.
Thanks for sharing your experience with all InMoovers 🙂

Regards,
Marten

very nice

WOW this and the previous post are GREAT, what software are you using?

very nice